The first step in configuring Jnet to work with PMDF is to install PMDF and Jnet on the same system. Once this is done a local Jnet channel should be set up. This is described below.
Note:
The PMDF CONFIGURE utility may be used to automatically configure your system with the appropriate BITNET channels. When the PMDF configuration utility is used, all of the necessary configuration steps except for those described in Section 3.11.1 are automatically done for you. Consult the OpenVMS edition of the PMDF Installation Guide for instructions on using the configuration utility. Innosoft strongly recommends that you use the supplied PMDF CONFIGURE utility.