%SYSTEM-F-NOLICENSE, operation requires software licenseis reported when attempting to send mail with PMDF, then the PMDF license is not properly loaded. Either the PMDF license PAKs need to be loaded, or the license needs to be enabled by PMDF. First check to see if the PMDF license is loaded by issuing the command:
$ SHOW LICENSE PMDF-productIf the PAKs have not been loaded, then load them. After the PAKs are loaded, if the license is for PMDF or PMDF-ACCESS, then also issue a PMDF LICENSE LOAD command. If the license does shows up properly and if the license is for PMDF or PMDF-ACCESS, then make sure PMDF's license units have been loaded by issuing the following command:
$ PMDF LICENSE LOAD
If PMDF reports that you have insufficient license units and you feel
that this is incorrect, then make sure that unlicensed cluster nodes
are not executing the pmdf_startup.com command procedure.
Note that if your license is for PMDF or PMDF-ACCESS, then PMDF LICENSE LOAD should respond with an informational message either to the effect that the units are loaded, or to the effect that they were already loaded.