This section describes using the web-based PMDF-LAN configuration utility. A command line variant, PMDF CONFIGURE LAN, is also available for sites for whom web configuration is not convenient; see the PMDF Obsolete Features for a discussion of the command line PMDF-LAN configuration utility. The web-based configuration utility may be used to generate an initial PMDF-LAN configuration, or may be used to generate a new configuration of an existing PMDF-LAN installation.
Using Netscape (version 3.0 or later) or Microsoft Internet Explorer (version 4.0 or later), with JavaScript enabled, connect to
http://localhost:7633/where
localhost is the TCP/IP name of your PMDF
system---you should see a page such as shown in Figure 12-1 -- and
then select the "Configuration Utilities" link; at this point
you should see a page such as shown in Figure 12-2 .
If your last use of the web-based PMDF configuration utility was to configure PMDF-MTA and your PMDF-MTA configuration has not been manually modified since then, you can "Load" your prior PMDF-MTA configuration session before beginning your PMDF-LAN configuration; or if you wish to redo your PMDF-MTA configuration, you may start by doing so now; either will minimize the number of checklist tasks you will later need to perform. Otherwise, you may configure just PMDF-LAN during this configuration sessions (and then perform checklist tasks to integrate your PMDF-LAN configuration into your main PMDF-MTA configuration).
Click on the "Configure" button for PMDF-LAN to begin the configuration.